Proudly Canadian
S8910U3000 : Resideo Honeywell S8910U3000 Universal Hot Surface Ignition Module
Compare at: $ 411.76
You Save: $ 37.43
SHIPS: IMMEDIATELY
Universal hot surface ignition module replaces multiple field installed hot surface ignition modules supplied by Resideo Honeywell, White-Rodgers, Robertshaw and Johnson. Uses a 120 VAC igniter. Includes cross reference, instructions, and accessories for easy replacement.
Replaces over 800 White-Rodgers, Robertshaw and Resideo Honeywell hot surface ignition models.
For 120 Vac (up to 5.0A) surface igniter (Norton 201/271 or equivalent).
S8910U 3000 Series has LED status indicator and microammeter ports for easy trouble shooting
For local (single rod) or remote (dual rod) rectification type flame sensing.
Contains easy-to-use cross reference and instructions plus the accessories required to replace the existing hot surface ignition module.
Provides one or three ignition trials (four-second or seven-second trials) per call for heat.
Field selectable number of ignition trials and trial time based on unit being replaced.
Igniter warm up time: 7 (12 seconds second and third trial), 17 (27 seconds second and third trial), 34, or 45 seconds
Product Downloads
Product Specifications
Installation Instructions
| Product Specifications | |
|---|---|
| Ambient Temperature Range (C): | -40 C to +79 C |
| Ambient Temperature Range (F): | -40 F to +175 F |
| Between Trial Time (sec): | (2) 96 sec (32 Seconds Prepurge and 64 seconds interpurge) |
| CSA Approved: | Design Certified |
| Dimensions (in): | 5 1/4 in. high x 4 1/16 in. wide x 1 15/16 in. deep |
| Dimensions (mm): | 133 mm high x 103 mm wide x 49 mm deep |
| Electrical Rating (amp): | 24 Vac |
| Flame Failure Response Time (sec): | 1.5 sec. |
| Flame Sense: | Single Rod or Two Rods |
| Frequency: | 50 Hz; 60 Hz |
| Ignition Sequence: | The number of trials for ignition and trial time is determined by the dip switch selection. |
| Ignition Source: | Line Voltage (120 VAC) Hot Surface Element (Norton Model 201 or 270) |
| Ignition System Type: | Direct Hot Surface Ignition |
| Ignition Trials To Lockout: | 1 or 3 |
| Ignition Trial Time (sec): | 4 sec. or 7 sec. |
| Lockout Timing: | 4 sec. or 7 sec. |
| Maximum Valve Load @ 24 Vac (Amps): | 2A |
| PrePurge: | 32 seconds |
| Tradeline Value: | Tradeline |
| Type of Gas: | Natural or LP |
| Typical Gas Control: | VR8205, VR8305 |
| Typical Ignition Hardware: | Norton 201, Norton 271, Q354 |
| Has 360 Photos: | Yes |
Replaces Old Numbers: 21N34, 85267647489, B0009784IY, B013JU93YG, S8910U1000, S8910U3000/U, W609192
ALTERNATIVE PARTS
ICM283 - $0.00
